[. . . ] Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. [. . . ] Never touch the blade, drill bit, grinding wheel or other moving parts during use. Never start a tool when its rotating component is in contact with the work piece. Never lay a tool down before its moving parts have come to a complete stop. ACCESSORIES : The use of accessories or attachments other than those recommended in this manual might present a hazard. REPLACEMENT PARTS : When servicing use only identical replacement parts. SPECIFICATIONS Voltage Chuck (mm) Switch No load speed (drill mode): - Lo speed - Hi speed Clutch Max. Spade Bit (mm) Weight - not incl. battery pack (KG) 18 V 2-13 Variable speed 0 - 450 min-1 0 - 1500 min-1 24 Positions 55 38 1. 89 2 English SPECIFICATIONS MODEL BATTERY PACK (not included) BPL-1820 BPL-1815 ABP1801 CDA1802 BATTERY PACK (not included) ABP1801 CHARGER (not included) BCL-1800 BCS618 CHARGER (not included) ACR-180 BATTERY PROTECTION FEATURES Ryobi 18 V lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. Under some operating conditions, these built-in features may cause the battery and the tool it is powering to act differently from nickel-cadmium batteries. During some applications, the battery electronics may signal the battery to shut down, and cause the tool to stop running. To reset the battery and tool, release the trigger and resume normal operation. NOTE: To prevent further shut down of the battery, avoid forcing the tool. If releasing the trigger does not reset the battery and tool, the battery pack is depleted. If depleted, the battery pack will begin charging when placed on the lithium-ion charger. Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the product before beginning operation. OPERATION WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below: Drilling in all types of wood products (lumber, plywood, panelling, composition board, and hard board) Drilling in ceramics, plastics, fiberglass, and laminates Drilling in metals Mixing paint This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. WARNING Always remove battery pack from your drill when you are assembling parts, making adjustments, assembling or removing bits, cleaning, or when not in use. Removing the battery pack will prevent accidental starting that could cause serious personal injury. 3 TO REMOVE BATTERY PACK Depress the latches on each side of the battery pack. [. . . ] WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. When drilling hard, smooth surfaces, use a center punch to mark the desired hole location. This will prevent the drill bit from slipping off-center as the hole is started. When drilling metals, use a light oil on the drill bit to keep it from overheating. [. . . ]